Inspection 1. Exhaust Throttle Valve Working Check Actuate the exhaust brake with the engine idling and make sure that you hear the valve strike on the stopper. Airtight Check Apply a negative pressure of -53.3 — -93.3 kPa (- 400 — -700 mmHg/-7.73 — -13.54 psi) to the pow- er chamber by means of a vacuum pump and make sure of the smooth opening/closing of the ex- haust brake valve. N6A1249E Legend 1. Power chamber 2. Adjust bolt 3. Valve 4. Close 2. Intake Throttle Valve Working Check Disconnect the vacuum hose from the actuator and try to move the rod by hand, making sure of the smooth move of the rod.
Apply a negative pressure of -86.7 — -93.3 kPa (- 650 — -700 mmHg/-12.57 — -13.54 psi) to the power chamber using a vacuum pump and make sure the average of measurements at Point A and Point B of the clearance between valve and body is as follows: 0.4 — 0.6 mm (0.016 — 0.024 in) (Minimum: 0.4 mm/0.016 in) If the clearance is out of this range adjust with the adjusting bolt. N6A1248E N6A1250E Legend 1. Vacuum hose 3. Exhaust Brake Magnetic Valve Inspection Connect the magnetic valve connector terminal No.1 and No.2 to (+) terminal and (-) terminal of battery respectively, and check the continuity be- tween the ports.