4) 4) DISASSEMBLY DISASSEMBLY Cleanliness is extremely important when Cleanliness is extremely important when repairing a steering control unit. Work in repairing a steering control unit. Work in a clean area. Before disconnecting lines, a clean area. Before disconnecting lines, clean port area of unit thoroughly. Use a clean port area of unit thoroughly. Use a wire brush to remove foreign material wire brush to remove foreign material and debris from around exterior joints of and debris from around exterior joints of the unit. the unit. We recommend that you keep the unit in We recommend that you keep the unit in a vise during disassembly. a vise during disassembly.
Follow the Follow the clamping procedures explained throughout clamping procedures explained throughout the manual. the manual. Clamp unit in vice, meter end up. Clamp lightly on edges of port face sides. Use protective material on vice jaws. Housing distortion could result if jaws are overtightened. (1) (2) Remove (5/16") cap screws. (3) Remove end cap. (4) Remove seal from gerotor. Screw-Cap Cap-End Seal •‹ Gerotor H940AC5SE03 5-22 Gerotor (Meter) End 25 mm [1 inch] Max. H940AC5SE02