(11) Carefully remove bearing and races, anti- cavitation valves and manual steering check valve (roll pin and ball) from bolt holes by tipping housing gerotor side down. Do not remove any valves other than manual steering check valve assembly and anti-cavitation valve assembly. All other valves are factory preset and are non-serviceable. Carefully Remove seal witha thin-blade screw driver. Do not scratch seal groove with screw driver. Use thin bladed screwdriver to pry dust seal from housing. Do not damage housing.
Dust Seal Manual Steering Check Valve (when applicable) (12) Roll Pin Ball Bearing Race O-ring Seal Ball Race (13) Roll Pin (14) H940AC5SE25 (15) Push pin from spool and sleeve assembly. (16) Remove Drive Standard Input Torque Spring/Spacer Package (17) Push spool partially from control end of sleeve, then carefully remove centering springs and retaining ring from spool by hand. Medium Input Torque Spring/Spacer Package Low Input Torque Spring/Spacer Package Standard input torque unit uses six centering springs and two spacers. Medium input torque unit uses four centering springs and three spacers. Low input torque unit uses four centering springs and two spacers. H940AC5SE26 5-24