JCB — 03 Direct-Mounted Attachments

03 - Attachments, Couplings and Load Handling 03 - Direct-Mounted Attachments 00 - General Remove and Install Figure 6. WARNING If two people are doing this job make sure that the person working the controls is a competent operator. If the wrong control lever is moved, or if the controls are moved violently, the other person could be killed or injured. Install 1. Keep the attachment on level ground. Refer to Figure 5. Figure 5. C B D C Quickhitch lever D Locking pins A Remove 1. The removal procedure is the opposite of the installation procedure. A Attachment frame B Lip of the frame 2. Drive the machine squarely up to the attachment frame. 3. Lower the lift arm. 4.

Tilt the quickhitch plate forwards. 5. Make sure that the top of the quickhitch plate is lower than the lip of the attachment frame. 6. Drive the machine until it touches the attachment frame. 7. Slowly tilt the plate backwards until it engages the attachment frame lip. 8. Raise the lift arm until the frame is in contact with the quickhitch plate, top and bottom. 9. Push the quickhitch levers fully inwards, to engage the locking pins and secure the attachment frame. 03 - 8 9813/6050-2 03 - 8