03 - Attachments, Couplings and Load Handling 10 - Excavator End Quickhitch 03 - Mechanical Quickhitch Remove and Install Figure 8. CAUTION When the quickhitch is installed and its attachment attached, It is possible to strike the cab and the underside of the boom or dipper with some attachments. Use great care with the boom and dipper to keep the attachment away from the operator cab. K A H E CAUTION When the quickhitch is attached to the machine, allowance must be made for the weight of the quickhitch on the rated operating load. The mass of the Quickhitch is stamped on the data plate. J C B F Install 1. Make the machine safe. G Refer to: PIL 01-03. D 2.
Make sure that the tipping lever locking bolt assembly is attached with the nut 1. K A Hole 1 B Hole 2 C Pivot pin 1 D Nut 2 E Hole 3 F Hole 4 G Pivot pin 2 H Bolt 1 J Bolt 2 K Nut 3 3. Put the quickhitch on hard and level ground. 4. Use suitable lifting equipment to move the quickhitch. 5. Position the machine so that the dipper arm and quickhitch are correctly aligned. 6. Engage the dipper. 6.1. Operate the controls to line up hole 1 in the dipper arm with the holes 2 in the quickhitch. Remove 6.2. Insert the pivot pin 1. 1. The removal procedure is the opposite of the installation procedure. 6.3. Install the bolt 1 and nut 2. 7. Engage the tipping link. 7.1.
Operate the controls to line up hole 3 in the tipping link with hole 4 in the quickhitch. 7.2. Insert the pivot pin 2. 7.3. Install the bolt 2 and nut 3. 03 - 18 9813/6050-2 03 - 18