Komatsu — 4.3.4 Servicing points

4. Disassembly, Inspection and Reassembly of Engines Point3: (Refer to 7.2.5 in chapter 7) [Disassemble] z Remove the mounting nut of the fuel injection pump drive gear, remove the gear using the gear puller, and remove the fuel injection pump. Do not forget to remove the stay on the rear side. When extracting the gear using the gear puller, use a pad at the shaft and carefully operate so as not to damage the thread. [Reassemble] z Tightening torque for fuel pump drive gear nut (without lube. Oil) m(kgf-m) N Point4 [Reassemble] z Assemble crankshaft gear A, fuel injection pump drive gear B and camshaft gear C at the same time by aligning with idle gear A, B and C marks.

z Install the idle gear shaft with the oil hole facing upward. Point5 [Reassemble] z Install the PTO drive gear with its inner spline side facing the flywheel. Point6 [Disassemble] z Install a bolt as a handle in the hole at the end face of the flywheel and remove carefully so as not to damage the ring gear. [Reassemble] Flywheel mounting bolt : apply lube oil m(kgf-m) N Point7 [Disassemble] z Measure the camshaft side gap. mm z If the measured side gap exceeds the limit, replace the thrust metal.

85 Model Tightening torque TNV82A 88 78 88 (8.0 9.0) 4TNV94L/98/106(T) 113 123 (11.5 12.5) Model Tightening torque 3TNV82A 88 83.3 88.2 (8.5 9.0) 4TNV94L/98/106(T) 186.2 205.8 (19.0 21.0) Item Standard Limit Side gap 0.05 0.20 0.30