4. Disassembly, Inspection and Reassembly of Engines 4.3.5 Parts inspection and measurement (1) Camshaft Mainly check the contact between the tappet and cam contact surface, bearing seizure and wear, and gear damage. (a) Shaft bend measurement Support the camshaft with V blocks. Rotate the camshaft and measure the runout at the center of the camshaft and at each journal with a dial gage. half of the runout is the bend. mm (b) Intake/exhaust cam height measurement mm (c) Camshaft outside diameter and bearing hole diameter measurement Measure the camshaft outside diameter with a micrometer.
The oil clearance shall be calculated by subtracting the measured camshaft outside diameter from the the camshaft bushing inside diameter after insertion to the cylinder measured with a cylinder gage. 87 Item Standard Limit Bend 0 0.02 0.05 Model Standard Limit 3TNV82A 88 38.600 38.800 38.350 4TNV94L・98 43.400 43.600 43.150 4TNV106(T) 50.900 51.100 50.650