Komatsu — 4.4.4 Servicing points

4. Disassembly, Inspection and Reassembly of Engines 4.4.4 Servicing points Point1: Oil pan [Disassemble] z Sealant is applied to the oil pan mounting surface on the block. Carefully operate soas not to damage or distort the bonding surface. [Reassemble] z Apply sealant (code No.977770-01212) before reassembly. Point2: Piston w/rod [Disassemble] z Measure the connecting rod side gap. mm z Carefully remove the carbon deposit on top of the cylinder so as not to damage the inner side of the cylinder. z Set the piston at the BDC position and remove the connecting rod cap. Then set the piston at the TDC position, and push the connecting rod big end with the wooden shaft of a hammer.

Proceed carefully so as not to cause the cylinder block catch the rod big end. Set the rod caps and crankpin metals in their correct combinations. [Reassemble] z Apply oil especially carefully to the sliding contact surfaces of the pistons, rods and rings. z Use the piston insertion tool (see 12.1-9 in Chapter 12) to insert each piston w/rod in the cylinder block and install the bearing metal cap. Rod bolt tightening torque N m(kgf-m) Point3: mounting flange [Disassemble] Place the engine on a stable base with the cylinder block upper surface facing down, and remove the mounting flange carefully so as not to damage the combustion surface.

91 Standard 0.20 0.40 Model Standard (apply lube oil) 3TNV82A 37.2 41.2 (3.8 4.2) TNV84 88 44.1 49.0 (4.5 5.0) 4TNV94L・98 53.9 58.8 (5.5 6.0) 4TNV106(T) 78.5 83.4 (8.0 8.5)