Komatsu — 4.4.5 Parts inspection and measurement

4. Disassembly, Inspection and Reassembly of Engines z Dimension R and finishing precision of crankshaft journal and pin As for grinding processing of journal and pin, machine it by using the grinding wheel of the dimension R of below table. Surface finishing precision standard on journal and pin: Ry=0.8S super polishing Surface finishing precision standard on the thrust side of crankshaft arm: mm [NOTICE] 1) lf the oil clearance is excessive though the thicknesses of the iournal and crankpin metals are normal or if partial uneven wear is observed, re-grind the crankshaft and use an oversized metals.

2) lf rust or surface roughening exists on the rear side of the metals, coat it with blue or minimum. Then assemble the crankpin metal to the connecting rod, and tighten the rod bolt to the specified torque to check the metal for contact. lf the contact surface occupies 75% or more, the metal is normal. lf the contact surface is insufficient, the metal interference is insufficient. Replace the metal with a new one. (1) Thrust metal inspection (a) Inspect any damage or wear. (b) Measure side gap and thrust metal thickness Side gap and thrust metal thickness mm If the side gap is exceeded, use an oversized thrust metal.

Oversized metal (0.25mm) 100 Model Finishing precision standard of dimension R 3TNV82A TNV84 88 3.5 +0.3/ 0 4TNV94L/98(T) 4TNV106(T) 4.0 +0.3/ 0 Model Side gap Thrust metal thickness Standard Limit Standard Limit TNV82A 88 0.14 0.22 - 1.930 1.980 1.850 4TNV94L 98 0.13 0.23 - 1.930 1.980 1.850 4TNV106(T) 0.13 0.23 - 2.430 2.480 2.35 - Code No. Standard thickness (mm) Upper Lower 3TNV82A ???119810-02940 (Up-down combination) 2.15 TNV84 88 129150-02940 (Up-down combination) 2.15 4TNV94L 98 129900-02370 129900-02360 2.055 2.105 4TNV106(T) 123900-02370 123900-02360 2.555 2.605