4. Disassembly, Inspection and Reassembly of Engines (c) Piston ring, ring groove and end clearance measurement z Except for the top ring, to measure the piston ring groove width, first measure the width of the piston ring. Then insert the piston ring into the ring. Then insert the piston ring into the ring groove. Insert a thickness gage in between the piston ring and groove to measure the gap between them. Obtain the ring groove width by adding ring width to the measured side clearance. z To measure the end clearance, push the piston ring into the sleeve using the piston head, insert a thickness gage in end clearance to measure. The ring shall be pushed in to approx.
30 mm above the bottom end of the cylinder. For the top ring, measure only the piston ring joint end clearance in normal state. 102