Komatsu — 7.2.1 Fuel system diagram

7. Fuel Injection Pump/Governor 7. FUEL INJECTION PUMP/GOVERNOR Only the outline of the MP fuel pump is explained in this chapter. Refer to the MP pump service manual of the separate volume for the disassembly and assembly. 7.1 Introduction It is described about the features of the fuel injection pump, YDP-MP, disassembly, assembly and adjustment procedure. Fuel injection pump is the most important equipment, which is enable to make the sensitive adjustment according to the variable load of the engine. Therefore all of the parts are required not only very precise machining but also finest, assembling with top level.

The careful arrangement of keeping off the dust and the rust when disassemble, adjustment and reassemble of the fuel injection pump is made in the market. YDP-MP Pump is a distributor type pump which is unified of Mono-plunger, a distributing shaft, a hydraulic head which equipped the delivery valve for each cylinder, pump housing which has a cam shaft internally and governor. The fuel, which is pressurized by the up and down movement of the plunger driven by the cam-rotation, is supplied through the distributor shaft, which is rotating accordingly. There are a model YDP-MP2 and a model YDP-MP4, and plunger diameter and fuel cam speed are different.

7.2 Fuel Injection Pump 7.2.1 Fuel system diagram 114