7. Fuel Injection Pump/Governor 7.2.4 Assembly procedure Reverse the disassembly procedure and adjust the fuel injection timing finally. See (4) of 2.2.7. 7.2.5 Servicing points Point 1 [Disassemble] z Block an entrance with the tape so that trash may not enter the fuel injection pipe and the fuel injection pump. Point 2 [Disassemble] z After putting the I.D. marks on the gearing part of the pump drive gear and the idle gear with paint and so on, remove the gear installation nut. [NOTICE] Don't remove four flange bolts. [Reassemble] z Reassemble the pump driving gear while checking the I.D. marks on the driving gear and idle gear.
Tightening torque of the gear installation nut 116 Model N m(kgf m) Lubricating oil application (thread portion, and seat surface) TNV82A 88 78 88 (8 9) Not applied 4TNV94 106(T) 113 123 (11.5 12.5)