Komatsu — 8.3.2 Inspection procedure

8. Turbochager 8.3.2 Inspection procedure (1) Rotor rotation inspection Inspect the rotor rotation by listening to any abnormal sound generation during rotation. For inspection with a sound detecting bar, bring the tip end of the bar into strong contact with the turbocharger case and raise the engine speed gradually. If any high pitch sound is generated at intervals of 2 to 3 seconds, the rotation is abnormal. Since the bearing or rotor may be defective in this state, either replace or overhaul the turbocharger. (2) Rotor play inspection Remove the turbocharger from the engine and inspect the rotor play in the axial and radial directions according to the procedure below.

After removing the turbocharger from the engine, always bind the oil inlet and outlet holes with adhesive tape. Rotor play in axial direction 124