9. Starting Motor (d) Armature and commutator run-out Use a dial gage and measure the armature core run-out and commutator run-out. Correct or replace if the limit is exceeded. mm (e) Commutator surface inspection If the commutator surface is roughened, grind with #500 to #600 emery cloth. (f) Commutator insulation depth Measure the depth of the insulating material between commutator segments, and correct it if it is less than the limit. mm 148 Standard Limit Armature 0.03 0.2 Commutator 0.03 0.2 Standard Limit 0.5 0.8 0.2