Komatsu — 9.1.5 Inspection and Maintenance

9. Starting Motor (4) Brush holder (a) Brush holder insulation test Check the continuity between the brush holder (+ side) and base (- side) with a multimeter. Good if no continuity exists. If continuity exists (insulation defect), replace the brush holder. (b) Brush spring inspection Inspect the brush spring pressure. N(kgf) Standard spring force 31 39 (3.1 3.9) (5) Magnetic switch When the starting motor is wetted with water, always replace the magnetic switch with a new even if the function is normal. (a) Shunt coil continuity test Check the continuity between the S terminal and the switch body. Good if continuity exists. If no continuity (coil disconnection), replace the magnetic switch.

150