Komatsu — 9.2.7 Assembly

9. Starting Motor (5) Pinion 1) Check the pinion teeth for wear and damage. Replace with a new one, if necessary. 2) Check if the pinion slides smoothly. If it is damaged or rusted or does not slide smoothly, repair. 3) Check springs for damage, and replace if necessary. (6) Ball bearing If abnormalities such as irregular noises are detected to the ball bearing, replace with a new one. 9.2.7 Assembly The assembly procedure is reverse of the disassembly procedure, but pay attention to the following points. (1) Apply grease as instructed below. (2) Armature thrust No adjustments are needed for the thrust.

(3) Gear shaft thrust Some thrust washers of 1.0 and 0.25 mm thickness are provided between the center bracket and gear shaft supporting surface. Make sure to check them at reassembly. If washers are deformed or worn, replace them with new ones. The appropriate thrust is from 0.05 to 0.3mm. If it is over 0.3mm, and the appropriate thrust washer, but pay attention so that the thrust is not 0. 173 Greasing point Grease type Sliding portions and head of plunger Pinion metal and metal portions of gear case Spline portions of pinion Sliding portions of shift lever NPC-FC6A Grease Deceleration gear MALTEMP SRL Grease