Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

section 4 gauges Before performing any operations within this section, review the “Safety Section” starting on page xviii. Operating the vessel without adequately operating gauges could result in permanent engine damage. NOTICE Gauges come in four distinct variations: the BY2 Classic, BY2 Unlimited, Serial i2200 series and the older Serial i2000 series. While similar in many aspects, each series has it’s own unique compatibilities and connections. The BY2 Classic system uses a serial tachometer with an LCD Display. Additional gauges including the speedometer are analog and require a traditional sender. No analog coolant or boost gauges are available with the BY2 Classic system.

For those parameters digital system gauges must be used. See pages 4:6 and 4:7 for explanation and diagram. The BY2 Unlimited for marine gear applications is supplied with the same tachometer as the BY2 Classic; however all additional gauges including the speedometer are digital (referred to as serial) gauges. The BY2 Unlimited for marine gear applications may, as an option, use the i5601E display. The BY2 Unlimited for stern drive applications always uses the i5601E, as that is required to calibrate the shift actuator. The serial gauges used with the BY2 Unlimited stern drive are the same gauges used with the 6LY3, 6CX and SY GEN III systems.

The 6LY3, 6CX and the SY GEN III always use the i5601E display. Therefore all round gauges used with these engines are serial gauges. The serial gauges used with the 6LY3 and 6CX are based on two different gauge families. Early 6LY3s used a series of gauges known as the i2000 Series. These always require a decoder box for each engine. The newer gauges on the 6LY3 and 6CX, and all gauges on the SY GEN III as well as the 2” gauges on the BY2 Unlimited are referred to as the i2200 series or simply serial gauges. They require a tachometer for each engine as that is where the CAN Bus data is decoded for the other gauges on that engine.

Because there are a variety of styles that can be used across a variety of engines, all part numbers in this section are shown in the table at the end of this section. Yanmar speedometer gauges will display Speed Over Ground (SOG) if a GPS is connected to the CAN Bus. If SOG is not available on the CAN Bus, then Speed Over Water (SOW) will be displayed instead if a paddle wheel is connected to the system. Note: In the February/March 2010 timeframe the 780757SDFB tachometer (green LED display) was replaced by the 780989SDFD (silver LED display). © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 4:1