4 Gauges Serial Gauges i2200 Series The i2200 Serial Gauge series, used on 6LY3, 6CX and SY GEN III and as an alternate gauge on the BY2 Unlimited, are similar in frontal appearance to the i2000 series but differ in most other aspects. Unlike the i2000 series, the i2200 series gauges do not require the i2001 box. It simply requires the Tach gauge to be connected to the CAN Bus first. Once the Tach gauge is connected to the CAN Bus, a connection is made to the speedometer and all other 2" gauges may be connected together in any order as long as one is connected to the Tach harness.
Front of i2200 series 3" gauge Back of i2200 series 3" gauge i2000 Series (discontinued) The i2000 Serial Gauge series, used on early 6LY3 engines, came in both 2" and 3" sizes, depending on function. They are connected to the CAN Bus through the i2001 Interface Module. Only one i2000 series gauge needs to be plugged directly into the i2001. Once this is done, there is a cable on the back of each gauge that connects to any other i2000 series gauge, which may be strung together in any order. Front of i2000 series 3" gauge Back of i2000 series gauge i2001 Interface Module © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 4:3