4 Gauges early 6LY3/SY Serial Gauge (i2000) Cut-outs and Mounting 3" Master Tachometer/Slave Speedometer Dimensions (in inches) Panel with Key Cut (recommended) Panel without Key Cut (See “Template Section” for “actual size” image) Note: Part number is on flat. 2" Minor Gauge Dimensions (in inches) Panel with Key Cut (recommended) Panel without Key Cut +0.508mm -0.000mm (0.156in) Note: Part number is on flat. (See “Template Section” for “actual size” image) Panel Mounting Proximity: The minimum distances between gauges on a panel are:
3.90" (99.1 mm) center to center for 3-inch to 3-inch (76.2-76.2 mm); 3.25" (82.5 mm) center to center for 3-inch to 2-inch (76.2-50.8mm); 2.60" (66 mm) center to center for 2-inch to 2-inch (50.8-50.8 mm). Panel Thickness: 0.059" to 1" (1.5-25.4 mm); Keying available for panels 0.080" (2 mm) or greater. Spin nut fastening available for panels 0.50" (mm) or less. Roughness and Curvature: Panels will be flat and smooth to within +/- 0.020" (0.5 mm) within any 3" (76.2 mm) diameter. Panel Offset: Bezel offset from mounting surface is .065" (1.7 mm) typical. © 2011 Yanmar Marine International • Rev.
2.0 4:30 Yanmar Electronic Control Systems Technical Manual 84.84mm+0.508 (3.340in)–0.000 FLAT CUT-OUT, AS REQ’D 4.064mm±0.127mm (0.160in) 8mm+0.000mm 70in) -0.508mm KEY SLOT, AS REQ’D 6.741mm+0.0000mm .415in) -0.0508mm 34mm +0.000mm 10in) -0.508mm 50.038 (1.970i FLAT CUT-OUT, AS 3.962mm ±0.127mm 038 970i KEY SLOT, AS REQ’D 41mm+0.0000mm 15in) -0.0508mm