Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

5 Control Heads General In general, all Yanmar electronic control heads with software Rev 1.09 and higher may be used with all electronic engines. Controls with software Rev 1.08 and earlier may not be used with the BY2 series of engines unless the software is updated to Rev 1.09 or higher. See below for more information. The different styles of controls may be mixed on an application. Thus different helm stations may have different styles of controls. All controls except those used on the system operate on the CAN Bus and meet NMEA 2000 ® specifications.

Controls with software revision 1.06 and higher (believed to be all units in the field at this time) may have their software updated using the CAN Bus. The most up-to-date information is covered in “Appendix A - Software Revision Listings” of this manual. In North America, if components require software updates, contact Yanmar America, in Adairsville, GA. It is NOT recommended the i5601E software be uploaded at the same time as any other devices on the CAN Bus. The operation of the controls is identical regardless of the engine type that is connected. Introduction All BY2 Unlimited, 6LY3, 6CX, and SY GEN III engine controls are NMEA 2000 ® certified and operate over a CAN Bus.

They allow other devices that are NMEA 2000 ® certified to work on the same CAN Bus. The controls are offered in a variety of styles and include a variety of functions. Key Control Features: CAN Bus based and NMEA 2000 ® certified. Single Lever and Single Function Controls are available. Mix or match controls at various stations. Up to four control stations are standard and additional stations are possible. Most units are factory calibrated. Control System Setup Setup and control system calibration are covered in “Section 3 - i5601E Digital Display” in this manual. Calibration of the Control Head (only) is covered later in this section.

Single Lever Controls Single Lever Controls have the throttle and shift on the same lever. One lever is used for each engine except when there are three or more engines. Note: Detent pressure and drag on CH6XXXX series controls can be adjusted using the adjusting screw on the front surface of the control head. © 2011 Yanmar Marine International • Rev. 2.0 5:2 Yanmar Electronic Control Systems Technical Manual