Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

5 Control Heads Mounting the Control Head CAUTION injury hazard Improper location of the control head could risk hand or finger injury. Determine a Proper Mounting Location The CH1900 control heads are designed to be mounted on flat vertical surfaces on port and starboard sides of the operator helm. The controls are designed to mount on surfaces from ѕ inch (19 mm) to 1-1/4 inch (32 mm) thick.

Since each control head is secured from the inside of the mounting surface, placement must allow clearance for the 5 inch (127 mm) diameter mounting flange, and access behind the mounting surface for attaching mounting hardware, making harness connections, and providing access to drag and detent adjustments. Placement of the control heads must allow for the full range of lever movement (156 degrees) without clearance problems. Be certain that control levers can be operated through their entire range without risk of hand or finger injury. See below for outline dimensions. Outline Dimensions © 2011 Yanmar Marine International • Rev. 2.0 5:18 Yanmar Electronic Control Systems Technical Manual