Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

5 Control Heads BY2 Classic Location of Control 1. Allow adequate clearance for hand and lever swing (forward and reverse positions, see page 5:39). 2. Allow adequate clearance under the console or in the gunwale for the cables AND allow a minimum of 36" from the cable nest connection with no restraint. When supporting the cables beyond 36", do not tie or clamp tightly. 3. After a suitable location for the control is determined, use the separate mounting template to make the cut-out. The templates are supplied with the control and in “Section 14 - Mounting Templates.” 4. Closely follow the instructions provided on the template. Cut & drill the mounting holes required.

On all models, the cover will have to be removed to expose the mounting holes. Measuring the Cables Measure the cable routing path from the control head connection to the engine connection. To transmission or stern drive shift connection Note: For minimumn cable bend radius refer to cable manufacturer’s specifications. Inboards and Stern Drives Measure from the control connection – along an unobstructed cable routing – to the shift connection. Round this dimension UP to the next whole foot and order the required cable part number. Note: Last two digits of the Teleflex cable number equal the length of the cable in feet. © 2011 Yanmar Marine International • Rev.

2.0 Yanmar Electronic Control Systems Technical Manual 5:35