6 Interface Modules SY Gen iii Fuel Sender Connections The i8350/55 Engine Interface box can handle two fuel senders. The sender inputs are both two wire inputs and may be used for single or double pole fuel sender applications. When used for single pole application the return line is connected to ground, preferably at the tank. When set for US calibration the range of both senders is 33 (full) to 240 (empty) ohms. When set for European calibration the range of both senders is 10 (empty) to 180 (full) ohms. The connections are made at the 8 pin connector of the i8350/55 Engine Interface. Cable CE43625 is included with the kit to aid with this connection.
The pinouts are shown in the table below: No connection to pin 4 and 5 results in US calibration. To change the setting to European calibration connect 4 and 5 of the 8 pin connector on the i8350/55 Engine Interface box. For US single pole senders the tank must have a good ground back to the main ground terminal post to operate accurately. Note: For tank “Instance” information, see page 4:25. 8 Pin Fuel Connector Note: Unit is supplied with US Calibration. The jumper to switch to European Calibration is attached to the cable. Water in Fuel This is a connection to the system that can be used to operate an alarm.
The i8350/55 Engine Interface Module generates a return to ground connection that is active low and rated for one amp. The signal comes out of the i8350/55 via the fuel harness CE43625, pin 8 of the 8 pin connector. The connector is an eight pin Deutsch DT style connector that is widely used in the marine industry. The contact used to make the connection is Deutsch 1062-16-0122. It fits 16 to 18 AWG wire. © 2011 Yanmar Marine International • Rev. 2.0 6:10 Yanmar Electronic Control Systems Technical Manual “Fuel” Pin No.
Signal Description Color Setting Calibration 1 Fuel Tank 1 Return Black 2 Fuel Tank 2 Return Black 3 Water in Fuel Return Black 4 Fuel Calibration Blue No connection for 33 - 240 Ohm senders 5 Fuel Calibration Blue Connect to pin 4 for 10 - 180 Ohm senders 6 Fuel Tank 1 Level Pink NMEA 2000® Instance “0” or “2” 7 Fuel Tank 2 Level Pink/White Tracer NMEA 2000® Instance “1” or “3” 8 Water in Fuel Brown