section 7 system default settings Before performing any operations within this section, review the “Safety Section” starting on page xviii. WARNING sudden movement hazard Changing some system settings will result in a different boat response to the controls. Proceed with caution after making setting changes. On 6CX Systems, if the “Default Monitor” command or the “Set System Default” command is selected the system will revert to a 6LY3 System and will need to be reset to a 6CX System. CAUTION All Yanmar engines with electronic control systems come with default settings installed. These settings allow the engine to start and operate as shipped.
They are based on the most frequently requested settings. There are many additional settings that allow the system to be optimized for a wide variety of applications and customer preferences. Many boat builders update the settings for a specific application. Dealers or customers may also change the settings to better match their preferences. The i5601E has a “Set System Defaults” command that returns the system to the factory default settings (see page 3:42). This feature has three purposes: • If someone has changed a number of the settings using the display, the unit can be easily reset.
• In the event of a problem, resetting the unit to the factory defaults will assure the problem is not one of setup. • Resetting the unit to the factory defaults allows easier communication with a service technician as all information will match the manual and both parties will then have the exact same setup. The “Set System Defaults” command returns the entire system to the factory default values. This also includes any parameters in the calibration menu. After a “Set System Defaults,” it might be necessary to calibrate the system again. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 7:1