Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

7 System Defaults BY2 unlimited Dual Engine Stern Drive Engine Interface part number i8150P**** i8150S**** Idle RPM not adjustable not adjustable Sync Cruise Cruise Lead Engine* Port Port Split Range Throttle 25% 25% Forward Throttle Curve F1 F1 Reverse Throttle Curve R1 R1 Programmable Shift Delay 4.8 4.8 Fixed Shift Delay 0 0 Station Select Protection Off Off Marine Gear Engine Interface part number i8150P**** i8150S**** Idle RPM not adjustable not adjustable Sync Cruise Cruise Lead Engine* Port Port Troll Trans Type ZF ZF Troll Engage RPM 800 800 Split Range Throttle 25% 25% Forward Throttle Curve F1 F1 Reverse Throttle Curve R1 R1 Programmable Shift Delay 4.8 4.8 Fixed Shift Delay 0 0 Station Select Protection Off Off Troll Mode** Full Full Troll Lever Travel 60% 60% Maximum Throttle in Troll Mode 40% 40% Troll Throttle Engage Delay 0.2*** 0.2*** Note:

A system reset may be needed for some changes to take effect. *Only shows when Sync is set to Power Train **Troll Mode functions are not displayed until Troll Mode is selected. ***Shows as “2” on the display. ****The i8150 Engine Interface Module has replaced previous i8130/i8140 as of February 2010. For stern drive configuration, the engine interface part number was i8130. For marine gear the part number was i8140. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 7:3