9 Connectivity SY GEN III SY GEN III Series Engines SY GEN III Power Diagram Outline Make all connections per ABYC standards. Make the following battery connections ONLY if you have successfully completed all prior steps. NOTICE 1. Battery positive to starter. This connection is normally made through the battery switch. The gauge of the wire depends on the length of the cable. 2. Battery negative to starter. The gauge of the wire depends on the length of the cable. 3. Connect a 12AWG (3.3 mm 2 ) wire from battery negative to engine block.
Emergency Start Connection Connect red wire with white tracer to terminal with white wire marked “50S” at starter solenoid (see page 6:9, pin 9 “remote start relay”). © 2011 Yanmar Marine International • Rev. 2.0 9:36 Yanmar Electronic Control Systems Technical Manual