Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

section 11 BY2 Unlimited Series Engines with Yanmar ZT350 STern drive Before performing any operations within this section, review the “Safety Section” starting on page xviii. WARNING sudden movement hazard When working on transmissions or shift connections, exercise caution as the boat motion versus the control action may have changed. This section covers the BY2 mechanical and electronic shift stern drives. For BY engines with mechanical shift see Appendix B. BY2 Unlimited Stern Drive applications typically use the Yanmar ZT350 Stern Drive with electric shift and an i8150 module. No actuator is required in this application.

The shift actuator is used on BY2 Unlimited Stern Drive applications that have mechanical shift. Power is supplied through the 50 or 80 amp breaker. The unit makes an audible beep when it is turned on. When the actuator is used, the quality of the mechanical cable that is used with the CAN Bus actuator is important. For short (less than 12 feet) cable runs with less than 180 degrees of total bends, and no sharp bends, most mechanical cables will work. For all other applications a Teleflex Extreme cable is required . Two barrels are supplied with each actuator to attach the mechanical cable to the actuator.

The brass barrel is used with SAE threads and the silver barrel is used with cables that have metric threads. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 11:1