Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

11 by2 Series Engines - Yanmar zt350 Stern Drive Shift Cable Installation for Mechanical Shift Type 1. Install the shift cable into the remote control. Refer to the appropriate instructions that come with the system you are using. Installing the Drive Unit Shift Cable 1. Insert the cotter pins from the top. Spread the ends of the cotter pins fully. 2. Loosen the stud and move it to the dimension as shown in the illustration below. Tighten the stud. (2) (2) (1) (1) 1 – Stud 2 – 76 mm (3 in.) - Center of the pivot bolt to the center of the stud. Setting the Cable Length Find the NEUTRAL position at the shift cable for the drive unit.

Measure the distance between the control cable barrel center and the center of the attachment hole of the cable end. Adjust it at the screw of the attachment if necessary, and then lock the nut. This distance should be 180.6 mm (7-7/64 in). (3) (4) (1) 1 – Short Cotter Pin 2 – Washers (2 ea.) 3 – Long Cotter Pin 4 – Drive Unit Shift Cable 2. Locate the center of the remote control and control cable play (backlash): (2) (a) Shift the remote control to NEUTRAL. (b) Push in on the control cable end with enough pressure to remove play, and mark position 2 on tube. 1 – Locknut 2 – 180.6 mm (7-7/64 in) - The control cable barrel center and the center of the attachment hole.

(c) Pull out on the control cable end with enough pressure to remove play and mark position 3 on tube. (d) Measure the distance between marks 2 and 3 and mark position 1 halfway between marks 2 and 3. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 11:3