Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

appendix A software revision listings Software revision update information i5601E (Version 3.0 and Version 4.01) BY2 Idle RPM adjustment BY2 Diagnostic trouble code’s added o Can read first two active DTC’s [P-code nr only] o Previously no code’s available ZT350 Smartstick® Trim Gauge calibration o In combination with i8150 Engine Interface module Extended NMEA2000 node information 6CX530 Setting [has to be selected manually] i8355 (Revision 1.01 for SY Engine with TwinDisc gearbox with Trolling) New software for use with Twin Disc trolling In case of SY with ZF gearbox, no need to update software In case of SY with ZF gearbox with trolling, no need to update software In case of SY with Twin-Disc gearbox, no need to update software In case of SY with Twin-Disc gearbox and trolling, please contact YMI for implementation of the improved software in the I8355 units.

CH67010/CH67020 XCIM (Revision 1.05 for XCIM) mproved XCIM start up behavior with no throttle input voltage Added 10 second startup delay before warning about pot failure Fixed “throttle problem” bit set when “Failover Command” input detected. Fixed throttle ramping up when throttle-input disconnected. Works for both single and dual levers. Fixed bug with throttle curve setting. o Was defaulted every time XCIM powers up, now it will only default if out of range. Increased transmit frequency for throttle-message from 50 ms to 40 ms © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual A:11