Appendix B Mechanical Shift Stern Drive Before performing any operations within this section, review the “Safety Section” starting on page xviii. WARNING sudden movement hazard When working on transmissions or shift connections, exercise caution as the boat motion versus the control action may have changed. The shift actuator was used on all BY Unlimited Stern Drive applications. When a stern drive is used with other than BY2 applications the shift actuator is used. Power is supplied through the 50 or 80 amp breaker. The unit makes an audible beep when it is turned on. The quality of the mechanical cable that is used with the CAN Bus actuator is important.
For short (less than 12 feet) cable runs with less than 180 degrees of total bends, and no sharp bends, most mechanical cables will work. For all other applications a Teleflex Extreme cable is required . Two barrels are supplied with each actuator to attach the mechanical cable to the actuator. The brass barrel is used with SAE threads and the silver barrel is used with cables that have metric threads. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual B:1