3 i5601E Digital Display sy gen iii SY GEN III Expanded Menu Performs the function indicated by a pop-up menu, if present. With no pop-up menu showing, briefly press to display the “Lighting & Contrast” menu. With no pop-up menu showing, press and HOLD to display the MAIN MENU. ALARMs / DIAGs MAIN MENU Diag Codes Alarms ALARMs / DIAGs Network Status USER SETTINGS MONITOR SETTINGS CALIBRATION Network Nodes Reset Maint. Time FACTORY SETTINGS MONITOR SETTINGS Rev Throt Curv 1 Fwd Throt Curv 8 HOT KEYS LOCK Split Range 25% Password Protected Prog Shift Dly 9.6 Station Protect N TROLLING software revision 4.01 Troll Mode: SPLIT Lever: 60% CALIBRATION Max Throttle:
40% VALVE CAL USER SETTINGS SHIFT ACTUATOR TROLLING SHIFT ACTUATOR FACTORY SETTINGS To FWD Gear: PUSH FWD Stroke: 20 ** Does not appear unless trolling option is on *** Not shown unless troll mode is split * Does not appear on single engine setups Eng Display: PORT Send to Unit REV Stroke: 25 Enter Idle RPM: 600 Lead Eng: Port Sync: Cruise TROLL Valve Setup T Engage Dly: 0.2 T RPM ENGAGE: 800 T Type: ZF Fixed Shift Dly: 0.2 Set System Defaults SYSTEM SELECT SYSTEM SELECT Sys Detect: Auto Engine: UNL Buttons: Trolling: N Engine Count: 1 Shift Acutator: N “Down” Arrow moves menu selection down. “Up” Arrow moves menu selection up. “Right” Arrow acts on current menu item.
“Back” moves back to previous menu. SHIFT ACTUATOR only present for Stern Drives © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 3:15 Units Menu Language Menu Tach Range 0-3000 SPEED Depth Offset Default Monitor Beeper ON About SETUP TROLL VALVE