3 i5601E Digital Display calibration Calibration User Settings Upon entry into the “User Settings” menu the software will obtain data from the network Engine Interface and Control Head Units. If necessary the software will try up to three times to connect and retrieve data from the units. The following status will be displayed: “Retry” will try to retrieve the settings again. This will give the user a chance to fix a problem and then retry again. “OK” to continue without retrieving the failed settings. If this is done some menu items will be missing and others will display “…” for not available data.
“Back” returns to the Main Menu If retrieval is successful, the user will be presented the “User Settings” menu. Check, Save Settings “Yes” will save settings. “No” will return back to Main Menu. All settings will be restored back and changes will be lost. “Back” returns to the User Settings menu. © 2011 Yanmar Marine International • Rev. 2.0 3:24 Yanmar Electronic Control Systems Technical Manual Engine Interface Processing Transfer OK Transfer Failed, Is ignition on? CAN Bus Control Head Processing Transfer OK Transfer Failed, Connection Problem?