SEBU8598 7 Safety Section General Hazard Information i05334609 General Hazard Information SMCS Code: 1000; 4450; 7405 Illustration 5 g00702020 Wear a hard hat, protective glasses, and other protective equipment, as required. Illustration 4 g00104545 When work is performed around an engine that is operating, wear protective devices for ears in order to help prevent damage to hearing. Attach a Do Not Operate warning tag to the start switch or controls before the engine is serviced or repaired. These warning tags (Special Instruction, SEHS7332) are available from your Cat dealer. Attach the warning tags to the engine and to each operator control station.
When appropriate, disconnect the starting controls. Do not wear loose clothing or jewelry that can snag on controls or on other parts of the engine. Ensure that all protective guards and all covers are secured in place on the engine. Do not allow unauthorized personnel on the engine, or around the engine when the engine is being serviced. Never put maintenance fluids into glass containers. Glass containers can break. Use all cleaning solutions with care. Cautiously remove the following parts. To help prevent spraying or splashing of pressurized fluids, hold a rag over the part that is being removed. Report all necessary repairs.
Unless other instructions are provided, perform the maintenance under the following conditions: Filler caps Grease fittings Pressure taps Breathers Drain plugs Use caution when cover plates are removed. Gradually loosen, but do not remove the last two bolts or nuts that are located at opposite ends of the cover plate or the device. Before removing the last two bolts or nuts, pry the cover loose in order to relieve any spring pressure or other pressure.