Caterpillar — Caterpillar C15 and C18 Engine Operation and Maintenance Manual

SEBU8598 71 Maintenance Recommendations Diesel Particulate Filter - Clean/Replace Note: Caterpillar recommends that an S·O·S Coolant Analysis (Level 1) be performed to check the concentration of SCA. Cooling system coolant additive contains alkali. To help prevent personal injury, avoid contact with the skin and eyes. Do not drink cooling sys- tem coolant additive. Maintain the Proper Concentration of SCA in the Coolant NOTICE Excessive supplemental coolant additive concentra- tion can form deposits on the higher temperature sur- faces of the cooling system, reducing the engine's heat transfer characteristics.

Reduced heat transfer could cause cracking of the cylinder head and other high temperature components. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Excessive supplemental coolant additive concentra- tion could also result in blockage of the heat exchang- er, overheating, and/or accelerated wear of the water pump seal. 1. Remove the cooling system filler cap slowly. 2.

Test the concentration of the SCA with a 286-2578 Nitrite Test Strip or review the results of the S·O·S Coolant Analysis (Level 1). Do not exceed the recommended amount of supple- mental coolant additive concentration. NOTICE Do NOT mix brands or types of SCA. Do NOT mix SCAs and extenders. 3. If necessary, drain some coolant in order to allow space for the addition of the SCA. 4. Add the amount of SCA required to maintain a concentration of 3 percent to 6 percent SCA in the coolant. Failure to follow the recommendations can result in shortened cooling system component life. 5. Clean the cooling system filler cap. Install the cooling system filler cap. NOTICE Use Only Approved SCAs .

Conventional coolants require the maintenance addition of SCA throughout their expected life. Do NOT use an SCA with a cool- ant unless specifically approved by the coolant suppli- er for use with their coolant. It is the responsibility of the coolant manufacturer to ensure compatibility and acceptable performance. For further information, refer to Special Publication, SEBU6251, “Cat Commercial Diesel Engine Fluids Recommendations”. i04880440 Diesel Particulate Filter - Clean/ Replace (If Equipped) Failure to follow the recommendations can result in shortened cooling system component life.

NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. SMCS Code: 108F-070; 108F-510; 1091-070; 1091- 510 Consult your Cat dealer when the DPF needs to be cleaned. The approved Caterpillar DPF maintenance procedure requires that one of the following actions be taken when the DPF needs to be cleaned:

Refer to Special Publication, NENG2500, “Cat Dealer Service Tool Catalog” and to Special Publication, GECJ0003, “Cat Shop Supplies and Tools” for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to applicable regula- tions and mandates.