Kaiyi — Kaiyi Power Train System Technical Manual

制 Mount inner installer (S) onto the disk carrier. 4 3 Install disk (1), compression spring (2), support shim (3) and L-ring (4). 2 1 侍 Installation position support shim and L-ring see TM161. S Inner installer : see figure TM160 7609ATM159 刷 Preload compression spring by means of assembly aid (S1) and pressure piece (S2), until L-ring has engaged into the annular groove. S1 S2 Assembly aid (S1) 5870 345 088 Assembly fixture (S 倜 S2) 5870 345 124 (Inner installer and pressure piece) 侍 It is always necessary to mount a new L-ring. 7609ATM160 Disk carrier with piston retraction :

2 1 3 1 Washer 2 Compression spring 3 Support shim 4 L-ring 5 Disk carrier 6 Drain valve (piston) 7 Piston with O-rings 5 6 7 4 7609ATM161 侍 Different clutches (disc arrangements with relevant disc clearance) can be installed, depending on the parts manual. 侍 The actually installed clutch and disc arrangement must be taken from the corresponding parts manual. 侍 Figure no. : TM162 and TM163 illustrates the different disc arrangements. 3-135