Kaiyi — Kaiyi Power Train System Technical Manual

Housing rear part : Housing rear part : (5) Legend see figure TM311. KR KV 侍 Place bearing outer rings into the bearing holes using assembly grease. If, contrary to the recommendation, the tapered roller bearings of clutches, input and output are not replaced, it is impera- tive to ensure the previous pairing (bear- ing inner ring/bearing outer ring). See figure TM054 and TM055. K4 AN K2 K1 K3 侍 AB 7609ATM312 侍 Due to the installation conditions, the installation of single clutches without using the special tool is not possible. AN Risk of injury. Risk of injury. (6) Install clutches by means of housing rear part (figure TM320 to TM321). KR 侍 Housing rear part will be removed again later.

Place KR clutch, AN input shaft and KV clutch into the housing rear part at the same time. 7609ATM313 (7) Slightly lift drive gear and position K4 clutch. AN K4 7609ATM314 (8) Mount K3 clutch. K3 7609ATM315 3-175