(2) Oil pressure pump Oil pressure pump 1 刮 Insert pressure relief valve (1) into the housing hole until contact is obtained. Mount two adjusting screws (S) and place gasket (2) and oil feed housing (3). 2 1 侍 Use assembly grease. S S Adjusting screws (M8) 5870 204 011 7609ATM350 刯 Install two adjusting screws (S) and mount stator shaft (1). 侍 Pay attention to radial installation position. 1 S Adjusting screws (M10) 5870 204 007 7609ATM351 侍 In case of wear marks in the pump housing or on the control disk, the pump assy must be replaced. 到 Install outer rotor. 侍 C h a m fe r ( s e e a r r ow ) t o s h ow downwards. 7609ATM352 刱 Install inner rotor. 侍 Teeth (see arrow) to show upwards.
7609ATM353 3-186