Ο Mount outer and inner disks in alternating order, starting with an inner disk. The installation clearance of the internal parts is corrected by mounting outer disks with different thicknesses. The difference in thickness between The difference in thickness between the left and the right disk package the left and the right disk package must only be 0.1 mm at maximum. must only be 0.1 mm at maximum. 7609AAX105 Determine the installation clearance Determine the installation clearance 0.2~0.7 0.2~0.7 mm mm Π Measure dimension I, from the mounting face of the differential housing to the plane face of the outer disk. Dimension I e.g. . . . . . . . . . . . . .
44.30 mm 7609AAX106 Ρ Measure dimension II, from the contact face of the outer disk to the mounting face on the housing cover. Dimension II e.g. . . . . . . . . . . . . 43.95 mm CALCULATION EXAMPLE : Dimension I . . . . . . . . . . . . . . . . 44.30 mm Dimension II . . . . . . . . . . . . . . . - 43.95 mm Difference = disk clearance = 0.35 Difference = disk clearance = 0.35 mm mm 7609AAX107 ц Any deviation from the required installation clearance is to be corrected with corresponding outer disks (s = 2.7, s = 2.9, s = 3.0, s = 3.1, s = 3.2, s = 3.3 or s = 3.5 mm ), taking care that the difference in thickness between the left and the right disk package must only be 0.1 mm at maximum. 3-230