Κ Insert both bearing outer rings (see arrows) into the brake housing until contact is obtained. 7609AAX147 Λ Insert the premounted brake housing by means of the lifting device over the output shaft until contact is obtained. ц Before clamping the seal rings (slide ring seal) to installation dimension, clean the sliding surfaces and apply an oil film. We recommend to use a leather cloth soaked with oil. 7609AAX148 Μ Insert back-up rings and grooved rings into the annular grooves of the brake housing (see arrows). ц Pay attention to the installation position; please also refer to sketch, page 3-244. 7609AAX149 Ν Clean the annular groove of the brake housing with spirit.
Then insert the guide ring into the annular groove (see also the following sketch) and fix it with loctite (type No. : 415) at its extremities (see arrows). ц The full circumference of the guide ring must be in an exact contact position. 7609AAX150 ц Upon installation the orifice of the guide ring must show upwards (12 o’clock). 3-243