侍# Some fault codes are not applied to this machine. 3-53 Fault code J1939 SPN J1939 FMI Reason Effect (only when fault code is active) 4245 5798 2 Aftertreatment diesel exhaust fluid dosing unit heater temperature - Data erratic, intermittent or incorrect. The aftertreatment diesel exhaust fluid dosing unit heater temperature is irrational. None on performance. 4249 4337 10 Aftertreatment diesel exhaust fluid dosing temperature - Abnormal rate of change. The aftertreatment diesel exhaust fluid dosing unit temperature is stuck. None on performance. 4251 5798 10 Aftertreatment 1 diesel exhaust fluid dosing unit heater temperature - Abnormal rate of change.
The aftertreatment diesel exhaust fluid dosing unit heater temperature sensor reading is stuck. None on performance. 4252 1081 31 Engine wait to start lamp - Condition exists. The received signal does not match the commanded signal. None on performance. 4259 5742 11 Aftertreatment diesel particulate filter temperature sensor module - Root cause not known. Intermittent battery voltage supply detected at the aftertreatment diesel particulate filter temperature sensor module. Possible reduced engine performance. 4261 5743 11 Aftertreatment selective catalytic reduction temperature sensor module - Root cause not known.
Intermittent battery voltage supply detected at the after treatment SCR temperature sensor module. Possible reduced engine performance. 4279 5848 21 Aftertreatment 1 SCR Intermediate NH3 - Data not rational - Drifted low. An in range low failure has been detected. Possible reduced engine performance. 4281 5848 2 Aftertreatment SCR Intermediate NH3 - Data erratic, intermittent or incorrect. The aftertreatment SCR intermediate NH3 sensor reading is stuck. None on performance. 4284 5793 9 Desired engine fueling state - Abnormal update rate. A valid message from the transmission ECU has NOT been received. Engine may not start or may be difficult to start.
4289 91 8 Accelerator pedal or lever position sensor 1 circuit frequency - Abnormal frequency or pulse width or period. The accelerator pedal position sensor reading is out of range. The engine will operate in limp home mode. 4452 520668 31 Aftertreatment outlet NOx sensor closed loop operation - Condition exists. The maximum dosing adjustment has been reached. Possible reduced engine performance. 4453 520669 31 Aftertreatment intermediate NH3 sensor closed loop operation - Condition exists. The maximum dosing adjustment has been reached. None on performance. 4517 237 13 Vehicle Identification number - Out of calibration.
The vehicle identification number has not been programmed into the ECM. None on performance.