Kaiyi — Kaiyi Power Train System Technical Manual

3-85 Problem Cause Remedy Transmission shifts too fast Wrong transmission controller. System pressure too high. Stuck PPC valve. Stuck or missing check valves. Missing O-ring from end of modulation orifice. Broken piston return spring. Incorrect transmission oil. Check if transmission controller has been changed Do transmission system pressure test. Remove and inspect PPC valve. Replace if necessary. Also remove end cover to inspect PPC valve and control valve housing. Replace if necessary. Inspect transmission control valve. Remove orifice and inspect port for O-ring. Disassemble and inspect clutch. Change oil (SAE 10W-30/15W-40).

Machine "creeps" in neutral Warped disks and plates in transmission. Check transmission. Transmission hydraulic system overheats High oil level. Low oil level. Wrong oil grade. Park brake dragging. Pinched, restricted or leaking lube lines. Machine operated in too high gear range. Malfunction in temperature gauge or sensor. Restricted air flow through oil cooler or radiator. Failed oil cooler bypass valve (In thermal bypass valve). Failed thermal bypass valve. Internally restricted oil cooler. Leakage in transmission hydraulic system. Malfunction in converter relief valve. Low transmission pump output. Transmission overfilled or hydraulic pump seal leaking. Add oil. Change oil.

Check for heat in park brake area. Check cooler lines. Operate machine in correct gear range. Install temperature sensor the verify temperature. Do tachometer/temperature reader installation procedure. Do radiator air flow test. Disassemble and inspect. Remove thermal bypass valve and check to see if machine still overheats. Do transmission oil cooler thermal bypass valve test. Do oil cooler restriction test. Do transmission system pressure, element leakage test. Do converter out pressure test. Do transmission pump flow test.