21. STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS 21.2 TORQUE LIST Unless otherwise specified, tighten the metric bolts and nuts to the torque shown in the table. The tightening torque is determined by the width across the flats @ of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Nm (newton meter): INm + 0.1 kgm Thread diameter Width across of bolt (mm) flat (mm) @I @I (a) (b) k9m Nm 8 13 3.2 rf:
0.3 31.4 * 2.9 6 10 1.35 + 0.15 13.2 k 1.4 12 19 11.5 _+ 1.0 112 f 9.8 10 17 6.7 + 0.7 65.7 + 6.8 16 24 28.5 + 3 279* 29 18 27 39+ 3 383rt 39 20 30 56 + 6 549k 58 22 32 76 + 8 745+ 78 24 36 94.5 f 10 927k 98 14 22 18.0 + 2.0 177+19 27 41 135+15 1320+140 30 46 175*20 1720+190 33 50 225k25 2210 + 240 36 55 280f 30 275Ok 290 39 60 335* 35 328Ok 340 NOTICE When tightening panels or other parts having tightening fixtures made of plastic, be careful not to use excessive tightening torque: doing so will damage the plastic parts. 3-l 7