Komatsu — 24.3 CHECK BEFORE STARTING

24. SERVICE PROCEDURE 24.3 CHECK BEFORE STARTING 24.3.1 CHECK COOLANT LEVEL, ADD WATER A WARNING Do not remove cap 0 while cooling water is hot. Hot water may spout out. When removing cap 0, wait until the water temperature goes down and release radiator pressure little by little by loosening caps slowly, then remove the cap. 1. Open the upper cover at the front of the machine, remove radiator cap 0 and check that the coolant level is in the shaded area. If level is low, add water. After adding water, tighten the cap securely. 2. 24.3.2 CHECK FUEL LEVEL, ADD FUEL A WARNING When adding fuel, never let the fuel overflow. This may cause a fire.

If spilling fuel, thoroughly clean up any spillage. 1. Check the fuel level using fuel gauge 0. 2. After completing work, fill the fuel tank through oil filler port 0. For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 3. After adding fuel, tighten the cap securely. Fuel capacity: 118 R NOTICE A clogged cap breather hole 0 may stop the the engine. Check it from time to time and clean. fuel flow to