11. EXPLANATION OF COMPONENTS 2. SAFETY LEVER (For steering and directional lever) 1 A WARNING l When leaving the operator’s compartment, set the safety lever securely to the LOCK position. If the con- trol lever is not locked, and it is touched by mistake, this may lead to a serious accident. l If the safety lever is not placed securely in the LOCK position, the control lever may not be properly locked. Lock y f16738 This locks the steering and directional lever. Move the steering and directional lever to the N (neutral) position and lower the lever to apply the lock. REMARK If the safety lever is not in the LOCK position, the engine cannot be started. 3.
FUEL CONTROL LEVER (For machines stopped by fuel control lever) This lever is used to control the engine speed and output. @ Engine stop position: Push the lever fully. @ Low idling position: Pull the lever from engine stop posi- tion 0 until you feel the operating force falls off. @ High idling position: Pull the lever fully. 3. FUEL CONTROL LEVER (For machines stopped by starting switch) This lever is used to control the engine speed and output. @ Low idling position: Push the lever fully. @ High idling position: Pull the lever fully. 2-9