11. EXPLANATION OF COMPONENTS 8. BLADE CONTROL LEVER Lifting and tilting control This lever is used to raise or tilt the blade. @ RAISE( L ) @ HOLD ( g ) Blade is stopped and held in this position. @ LOWER ( & ) 0 FLOAT ( ,b I Blade will move freely according to external force. When released from FLOAT position, this lever will to HOLD position, so it must be moved back by hand. not return @ LEFT TILT ( m& ) @ RIGHT TILT ( i,Q., ) (Hydraulic angle-tiltdozer) Blade condition Tilt (mm) D31 E-20, D37E-5 1 D31 P-20A.
D37P-5A Right tilt I Left tilt F07032 Left angle, left tilt (Hydraulic tiltdozer) Machine model 1 Tilt (mm) Angling control (For hydraulic angle-tiltdozer only) Place the lever in the neutral (HOLD) position. Keep the switch at the tip of the lever pressed and operate the lever to the left or right to angle the blade. @ LEFT ANGLE ( 1 @ HOLD: Blade is stopped and held in this position. @ RIGHT ANGLE ( @ ) Blade can be angled at 25” on both right and left sides. 2-l 1