Komatsu — 15.2 DURING STORAGE

15. LONG-TERM STORAGE 15.1 BEFORE STORAGE When putting the machine in storage for a long time, do as follows. After every part is washed and dried, the machine shall be housed in a dry building. Never leave it outdoors. In case it is indispensable to leave it outdoors, park the machine on the flat ground and cover it with canvas etc. Completely fill the fuel tank, lubricate and change the oil before storage. Apply a thin coat of grease to metal surface of the hy- draulic piston rods and the idler adjusting rods. Disconnect the negative terminals of the battery and cover it, or remove it from the machine and store it separately.

If the ambient temperature is expected to drop below o”, always add antifreeze to the cooling water. Lock each control lever with the safety lock and place the fuel control lever in the low idling position. Do not lock the brake pedal; use blocks to stop the machine from moving. 15.2 DURING STORAGE A WARNING If it is unavoidably necessary to carry out the rust- preventive operation while the machine is indoors, open the doors and windows to improve ventilation and pre- vent gas poisoning. l Operate the engine and move the machine for a short dis- tance once a month so that a new film of oil will be coated over movable parts and component surfaces. At the same time, also charge the battery.

l Before operating the work equipment, wipe off the grease on the hydraulic piston rod. 2-49