18. OUTLINES OF SERVICE 18.2 RELATING TO HYDRAULIC SYSTEM Use extreme caution when servicing the hydraulic system, because after the operation is very hot. Also, high pressure is applied in the but also after the operation. oil in the system soon system not only during Services relating to the hydraulic system are (1) daily check of oil replacement and (3) periodic oil replacement. level, (2) periodic filter Always bleed the air from the circuit after replacing the filter or changing the hydraulic oil. When a component, such as a hose, in the line is disconnected, check O-rings for flaws and replace them if necessary.
If the hydraulic cylinders or any part of the hydraulic circuit have been removed, bleed the air as follows after completion of assembly. 1. Run the engine at low idling. 2. When extending and retracting the cylinders for the first 4 - 5 times, stop approx. 100 mm from the end of the stroke. 3. For the next 3 - 4 times, operate each cylinder to the end of its stroke. 3-8