18.4 RELATING TO LUBRICATION Lubrication is to help smooth operation of the machine and work equipment. It prevents the machinery from being subjected to excessive load and from getting caught or generating noise. There are two lubricating methods; using oil and using grease. Services relating to the lubrication are (1) check of oil level, (2) changing oil for oil lubrica- tion and (3) adding grease for grease lubrication. The machine has grease nipples in places. Some of the nipples are not mentioned in this manual. These are equipped for overhaul purpose, and no greasing is required for them. Always use only lubricants specified in “20.
USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. After adding grease, wipe off old grease that was forced out, especially on rotating parts that will be worn by sand and dirt adhering to them. There are nipples on positions such as the lever linkage, which are not mentioned in this manual. These nipples are oil seal type and require no regular greasing. Add grease if the linkage does not move smoothly after the machine has been operated for a long time. Maintain oil at the proper level. Both too high and too low oil levels are not good for the machine. 3-10