MAINTENANCE SECTION 5 Page 33 ELECTRICAL SYSTEM INSTUMENT PANEL LIGHTS For a bulb replacement carry out as follows: 1. Remove the instrument panel mounting screws and lift it and shift to the side. 2. Pull the bulb socket free. 3. Press in the bulb, turn it home counterclockwise and remove it form the socket. 4. Install a new bulb, press it in home and turn it clockwise. 5. Install the socket with the bulb. 6. Secure the instrument panel with the screws. FRONT AND REAR DRIVING LIGHTS, INDICATORS, STOP AND TAIL LAMPS All lights are demountable from outside. For a bulb replacement carry out as follows: 1. Remove the screws mounting the optical element. 2. Remove the optical element. 3.
Replace the bulb. 4. Reassemble in the reverse order. Back up lights, stop and rear indicators are mounted on a folding bracket to position them as required by the traffic regulations. ECM WARNING LIGHTS BULBS Use genuine bulbs only 5.10.4. BATTERIES The loader is equipped with 4 standard maintenance free batteries located in the compartment to the left-hand side of the hydraulic reservoir. When equipped with 2 maintenance free batteries or 8 batteries for arctic version, they will be located in compartments on each side of the hydraulic reservoir. When standard batteries are used, the right hand compartment may be used as a tool storage compartment. WARNING!
Batteries give off a highly flammable gas. Do not smoke or allow sparks open flame near the batteries because a fire or explosion could result. WARNING! Battery acid causes severe burns. Avoid contact with eyes, skin, or clothing. Wear goggles, rubber glove, and apron. If eye contact occurs, flush with water for 15 minutes and get prompt medical attention. If skin contact occurs, flush with water. WARNING! When using a booster battery and jumper cables, connect the negative (ground) cable to the machine's frame, away from the battery. Always connect the ground cable last and disconnect it first to avoid sparks near the battery. A spark could cause a battery explosion and injury. WARNING!
Never check the battery charge by placing a metal object across the terminals. The sparks could cause a battery explosion. Use a voltmeter or hydrometer to measure the charge. WARNING! Be sure the electrical system disconnect switch is off when connecting or disconnecting batteries to minimize the chance of sparks and explosion. DRESSTA OM560C99/1E