MACHINE TRANSPORT AND STORAGE SECTION 3 Page 3 3.1. MACHINE TRANSPORT 3.1.1. GENERAL ATTENTION! During transportation of the machine the front and rear frame should be blocked by means of special connector and interlocking pins. A frame locking bar and two pins (Fig. 3.1 and Fig. 3.2) - in stowed position are provided on the LH side of a loader. They are used to lock the front and rear frame of the loader to prevent accidental frame turning during service and lifting on lifting slings. METHOD OF LOCKING OF FRONT AND REAR FRAME OF THE LOADER Prior to operating of the machine place the locking bar in the stowed position as shown in Fig. 3.1.
Repair or replace the frame locking bar and pins if damaged or lost to ensure frame locking, Fig. 3.2. Fig. 3.1. Frame Locking Bar and Pins in stowed position Fig. 3.2. Frame Locking Bar and Pins in locked position Always tie down securely the machine for transport to prevent movement. ATTENTION! When transporting the machine be especially careful during loading and unloading. Load and unload the machine on even surface that makes full support for the machine and transport facility. Block the transport facility so that it cannot move. Make use of loading platform of sufficient strength, small approach angle and appropriate height. 1.
Clean clay, oil and other slippery material of the loader tires. 2. The hydraulic, cooling and braking system should be filled up. 3. The fuel tank should be filled with app. 60 l of fuel. 4. The parking brake should be applied. The pressure in the tires should conform to this instruction TIRES, Section 6. 5. The batteries should be fully charged, the electric system master switch turned off. 6. The ignition switch should be in the neutral position and the ignition key removed. ATTENTION ! When transporting this machine on a high speed carrier or railaway car, seal the exhaust pipe openining to prevent turbocharger damage. ATTENTION !
When the reserve level of fuel is signalled, drive on trailer bed or ramps of grade exceeding 10° reverse to prevent aeration of the engine fuel system. DRESSTA OM560C99/1E